Impreza Outback Sport AWD F4-2.5L SOHC (2002)
CAUTION:
^
Place a wooden block as shown in the figure to prevent damage to piston.
^
Do not apply excessively high-pressure.
4) Remove the piston seal from caliper body cylinder.
5) Remove the lock pin sleeve and boot from caliper body.
6) Remove the guide pin boot.
ASSEMBLY
1) Clean the caliper body interior using brake fluid.
2) Apply a coat of brake fluid to the piston seal and fit piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4) Insert the piston into cylinder.
CAUTION: Do not force the piston into cylinder.
5) Apply a coat of specified grease to the boot and fit in the groove on ends of cylinder and piston.
Grease: NIGLUBE RX-2 (Part No. 003606000)
6) Install the piston boot to the caliper body, and attach boot ring.
7) Apply a coat of specified grease to guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. 003606000)
8) Install the guide pin boot on caliper body.
9) Install the lock pin boot on caliper body and insert lock pin sleeve into place.
