Impreza Outback Sport AWD F4-2.5L SOHC (2002)
Electronic Brake Control Module: Service and Repair
REMOVAL
1) Disconnect the ground terminal from battery.
2) Remove the air intake duct from engine compartment to facilitate removal of ABSCM & H/U.
3) Use an air gun to get rid of water around the ABSCM & H/U.
CAUTION: The contact will be insufficient if the terminal gets wet.
4) Pull off the lock of the ABSCM & H/U connector to remove it.
5) Disconnect the connector from ABSCM & H/U.
CAUTION: Be careful not to let water or other foreign matter contact the ABSCM & H/U terminal.
6) Unlock the cable clip.
7) Disconnect the brake pipes from ABSCM & H/U.
CAUTION: Wrap the brake pipes with vinyl bag to avoid spilling brake fluid on vehicle body.
8) Remove the ABSCM & H/U from engine compartment.
CAUTION:
^
ABSCM & H/U cannot be disassembled. Do not attempt to loosen the bolts and nuts.
^
Do not drop or bump the ABSCM & H/U.
^
Do not turn the ABSCM & H/U upside down or place it on its side.
^
Be careful to prevent foreign particles from getting into the ABSCM & H/U.
^
Apply a coat of rust-preventive wax (Nippeco LT or GB) to bracket attaching bolt after tightening.
^
Do not pull the harness when disconnecting connector.
INSTALLATION
1) Install the ABSCM & H/U bracket.
Tightening torque: 32 Nm (3.3 kgf-cm, 24 ft. lbs.)
2) Install the ABSCM & H/U.
CAUTION: Confirm that the specifications of the ABSCM & H/U conforms to the vehicle specifications.