Impreza RS Coupe AWD F4-2.5L DOHC (1998)
b. The vehicle courtesy light and DOOR AJAR indicator will turn on.
c. The parking lights will flash once.
4. Press and hold UNLOCK on the same transmitter.
a. All doors will unlock.
5. Repeat steps 3 and 4 with the second remote transmitter.
F. Warning Label Installation
1. Open the hood and clean any dirt or oil from the radiator support in the area located directly in front of the battery.
2. Adhere the label to the radiator support (label has large lettering).
3. Clean any dirt and oil from the black/yellow (ground) battery cable in an area located approximately 3" from the battery terminal.
4. Adhere the battery cable label to the clean area (label has small lettering).
G. Mounting the Module
1. Mount the keyless entry module to the bracket using the supplied screws and nuts as shown.
2. The hole at the top of the module bracket will fit onto a threaded bolt behind the fuse block. To find the bolt, reach behind the fuse block. There
are two bolts extending downward, mounted approximately 3 inches apart. The module bracket will mount to the bolt closest to the passenger side
of the vehicle.
3. Fit the bracket onto the bolt, with the module SUBARU label facing the front of the vehicle. Use the supplied 1O mm nut to secure the bracket and
module. Tighten to 45-60 inch lbs.
H. Notes on System Operation
1. Parking lights will flash when the vehicle battery is disconnected and reconnected. To stop lights from flashing, either:
a. Press remote transmitter Unlock button once.
b. Turn ignition to the "ON" position and press programming button for one second (mounted on trim beneath diagnostic connector).
2. The vehicle courtesy light and DOOR AJAR indicator will stay on tor 60 seconds upon exiting the vehicle unless the door is locked with the
remote transmitter.
3. The instrument panel lights will tlash when the parking lights flash.
IMPORTANT!! If installing the Security Upgrade system at the same time as the Keyless Entry system, review now the Security Upgrade
instructions to continue the installation procedure.
Finishing the Installation
1. Route the WHITE/BLACK antenna wire (8" wire extending from the side of the module) away from the module and surrounding harnesses. Keep
the antenna as straight as possible. Make sure the end of the antenna does not make contact with metal.
Note: The antenna is cut to the appropriate length to ensure optimum performance. Do not cut or add wire to the antenna.
2. Using the supplied short tie wraps, secure the system wiring harness to existing wiring harnesses so that they are concealed and clear of any
