Impreza RS Coupe AWD F4-2.5L SOHC (1999)
Brake Pedal Assy: Service and Repair
ON-CAR SERVICE
Brake Pedal
1) Check position of pedal pad.
Pedal height: L 148 mm (5.83 inch)
(1) Stop light switch
(2) Mat
(3) Toe board
(4) Brake booster operating rod
2) If it is not in specified value, adjust it by adjusting brake booster operating rod length.
3) Measure the clearance between threaded end of stop light switch and stopper. If it is not in specified value, adjust it by adjusting position of stop
light switch.
(1) Stop light switch
(2) Stopper
(3) Brake pedal
CAUTION: Be careful not to rotate stop light switch.
Stop light switch clearance: A 0.3 mm (0.012 inch)
4) Apply grease to operating rod connecting pin to prevent it from wearing.
Clutch Pedal
1) Push release fork until operating cylinder push rod retracts. Check that clutch fluid level in reservoir tank increases.
2) If clutch fluid level increases, hydraulic clutch play is correct.
3) If clutch fluid level does not increase or push rod does not retract, clutch pedal must be adjusted.
4) Check the fluid level on the outside of the clutch master cylinder tank. If the level is below "MIN", add clutch fluid to bring it up to "MAX".
