subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

ABOUT US
Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 4235 > < Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 4233

Impreza RS Coupe AWD F4-2.5L SOHC (1999)

Page 2
background image

7. Using steering puller, remove steering wheel.

CAUTION: Do not allow connector to interfere when removing steering wheel

8. Remove steering column covers.

9. Removing three retaining screws, remove combination switch.

CENTERING ROLL CONNECTOR

Note: Before installing steering wheel, make sure to center roll connector built into combination switch.

1. Make sure that front wheels are positioned straight ahead.

2. Install steering gearbox, steering shaft and combination switch properly. Turn roll connector pin (1) clockwise until it stops.
3. Then, back off roll connector pin (1) approximately 2.65 turns until "Arrow" marks aligned.

INSTALLATION

CAUTION: Failure to do this might damage roll connector.

Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 4235 > < Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 4233