subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Recall - Air Flow Meter Contamination|Page 243 > < Recall - Air Flow Meter Contamination|Page 241
Page 5
background image

3)

Reinstall the air intake housing back into the engine compartment. Ensure clamps are tightened properly; failure to do so will cause a vacuum leak.

4)

Reconnect the vehicle wire harness to the air flow meter sensing unit.

Note:

If the "Check Engine" light is illuminated when the vehicle arrives for service, use the Select Monitor to recover stored trouble codes. If
trouble code P0170 is found, replacing the Air Flow Meter Sensing Unit should correct the condition. Clear the ECM memory. If any other
codes are found, refer to the applicable service manual for trouble code diagnostic procedures.

SERVICE PROGRAM IDENTIFICATION LABEL

Type or print the necessary information on a Service Program identification label. The completed label should be attached to the vehicle's upper radiator
support.

A quantity of labels is provided to each dealer with this bulletin. Additional labels are available through your Area/Distributor Service 0ffice.

CALIFORNIA/MASSACHUSETTS "VEHICLE EMISSION RECALL - PROOF OF CORRECTION" CERTIFICATE

The California Air Resources Board and the Department of Motor Vehicles Registration/Recall Program requires that all emission related
Recall/Campaign or Service Program repairs be completed before a vehicle registration is renewed. Please provide owners of vehicles registered in the
states of California and Massachusetts a completed "Vehicle Emission Recall - Proof of Correction" certificate. Vehicle owners should be advised to
retain this certificate because the California/Massachusetts Department of Motor Vehicles may require they provide proof this service program repair has
been completed.

CLAIM REIMBURSEMENT AND ENTRY PROCEDURES

Recall - Air Flow Meter Contamination|Page 243 > < Recall - Air Flow Meter Contamination|Page 241