Impreza Sedan FWD F4-1820cc 1.8L SOHC (1995)
3) Check rubber parts for damage or deterioration.
Assembly
ASSEMBLY
1) Clean caliper body interior using brake fluid.
2) Apply a coat of brake fluid to piston seal and fit piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4) Insert piston into cylinder.
CAUTION: Do not force piston into cylinder.
5) Apply a coat of specified grease to boot and fit in groove on ends of cylinder and piston.
Grease:
NIGLUBE RX-2 (Part No.003606000)
6) Install the piston boot to the caliper body, and attach boot ring.
7) Apply a coat of specified grease to guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
Grease:
NIGLUBE RX-2 (Part No.003606000)
8) Install guide pin boots on caliper body.
9) Install lock pin boots on caliper body and insert lock pin sleeve into place.
Installation
INSTALLATION
1) Install disc rotor on hub.
2) Install support on back plate.
Tightening torque:
52 ± 6 Nm (5.3 ± 0.6 kg-m, 38.3 ± 4.3 ft-Ib.)
