Impreza WRX F4-2.0L DOHC Turbo (2004)
3. Apply grease to the sleeve.
4. Tighten the adjusting screw by two threads.
5. Apply liquid packing to at least 1/3 of entire perimeter of adjusting screw thread.
Liquid packing: THREE BOND 1141
6. Tighten the adjusting screw to 7.4 Nm (0.75 kgf-m, 5.4 ft. lbs.) and back off 25°.
7. Install the lock nut. While holding adjusting screw with a wrench, tighten the lock nut using ST.
ST 926230000 SPANNER
Tightening torque (Lock nut): 39 Nm (4.0 kgf-m, 29 ft. lbs.)
NOTE:
^
Hold the adjusting screw with a wrench to prevent it from turning while tightening lock nut.
^
Make adjustment so that the steering wheel can be rotated fully from lock to lock without binding.
21. Check for service limit as per article of "Service limit". Make replacement and adjustment if necessary.
22. Take off the gearbox from ST.
23. Install the four pipes on the gearbox.
1. Connect the pipe A and B to the gearbox.
Tightening torque: 13 Nm (1.3 kgf-m, 9.4 ft. lbs.)
2. Connect the pipe E and F to the gearbox.
Tightening torque:
Pipe E: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
Pipe F: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
