Impreza WRX F4-2.0L DOHC Turbo (2004)
7) Install the oil cooler pipes.
Note: Be sure to use a new copper washer.
Tightening torque:
T1: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
T2: 40 Nm (4.1 kgf-m, 30 ft. lbs.)
T2: 44 Nm (4.5 kgf-m, 32.5 ft. lbs.)
8) Install the transmission rear crossmember bolts.
Tightening torque: 70 Nm (7.1 kgf-m) 51 ft. lbs.)
9) Install the propeller shaft.
10) Install the shield cover. (if equipped)
11) Install the front, center, rear exhaust pipes and the muffler. (Non-turbo model)
12) Install the center and rear exhaust pipes and the muffler. (Turbo model)
13) Lower the vehicle.
14) Install the transmission connector to the stay.
15) Install the air cleaner case. (Non-turbo model)
16) Install the intercooler. (Turbo model)
