Impreza WRX F4-2.0L DOHC Turbo (2004)
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2) Adjust the select cable.
3) Install the rear vehicle speed sensor.
Tightening torque:
T: 7 Nm (0.7 kgf-m, 5.1 ft. lbs.)
4) Install the transmission rear crossmember.
1) Tighten bolts.
Tightening torque:
T1: 35 Nm (3.6 kgf-m, 26 ft. lbs.)
T2: 70 Nm (7.1 kgf-m, 51 ft. lbs.)
2) Remove the transmission jack.
5) Install the propeller shaft.
6) Install the front, center, rear exhaust pipes and the muffler.
7) Install the center and rear exhaust pipes and the muffler.
8) Connect the transmission harness connector
9) Install the pitching stopper.
10) Install the air cleaner case. (Non-turbo model)
11) Install the intercooler. (Turbo model)
12) Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.
13) Check the ATF level.
