Impreza WRX F4-2.5L DOHC Turbo (2006)
Engine Control Module: Service and Repair
Engine Control Module (ECM)
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the lower inner trim of the passenger side.
3. Detach the floor mat of the front passenger seat.
4. Remove the protect cover.
5. Remove the nuts (A) which hold ECM to the bracket.
6. Remove the clip (B) from the bracket.
7. Disconnect the ECM connectors and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
When replacing ECM, use of wrong spec. ECM may lead to damage to the fuel injection system.
-
When replacing ECM, do not damage the harnesses and connectors.
Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb)
