Impreza WRX F4-2.5L DOHC Turbo (2006)
5) Install the DOJ inner race on shaft, and fit the snap ring with pliers.
NOTE:
Confirm the snap ring is completely fitted in shaft groove.
6) Install the cage, which was previously fitted, to inner race fixed upon shaft.
NOTE:
Fit the cage with protruded part aligned with the track on inner race, and then turn by a half pitch.
7) Fill 80 to 90 g (2.82 to 3.17 ounces) of specified grease into the interior of DOJ outer race.
8) Apply a coat of specified grease to cage pocket and six balls.
9) Insert six balls into cage pocket.
10) Align the outer race track and ball positions and place in the part where shaft, inner race, cage and balls are previously installed, and then fit the
outer race.
