Impreza WRX STI F4-2.5L DOHC Turbo (2007)
6. Expand the pads and push piston back.
7. Remove the pad.
INSTALLATION
1. 14 INCH TYPE
1. Apply a thin coat of Molykote AS-880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
2. Install the pads on support.
3. Install the caliper body on support.
Tightening torque: 37 Nm (3.8 kgf-m, 27.5 ft. lbs.)
NOTE: If it is difficult to push the piston during pad replacement, loosen the air bleeder screw to facilitate work.
2. 15 INCH TYPE
1. Apply a thin coat of Molykote AS-880N (Part No. K0777YA010) to the frictional portion between pad and pad inner shim.
2. Install the pads on caliper body.
3. Install the cross spring.
4. Install the pad pin on caliper body.
5. Install the M clip.
3. 17 INCH TYPE
1. Apply a thin coat of Molykote AS-880N (Part No. K0777YA010) to frictional portion between pad and pad inner shim.
2. Install the pads on caliper body.
3. Install the cross spring and pad pins.
4. Install the clip.
INSPECTION
1. 14 INCH TYPE
Check pad thickness A.
