Impreza WRX STI F4-2.5L DOHC Turbo (2007)
5. Remove the caliper body from housing.
6. Clean mud and foreign particles from the caliper body assembly and support.
3. 17 INCH TYPE
CAUTION: Do not allow brake fluid to come in contact with vehicle body; wash away immediately with water and wipe off completely if
spilled.
1. Set the vehicle on a lift.
2. Loosen the wheel nuts.
3. Lift-up the vehicle, and then remove the front wheel.
4. Remove the brake pads from caliper body.
5. Remove the union bolt (1) and brake hose from caliper body assembly.
6. Remove installation bolts (2) from housing.
7. Clean mud and foreign particles from the caliper body assembly.
INSTALLATION
1. 15 INCH TYPE
1. Install the support on housing.
Tightening torque: 80 Nm (8.2 kgf-m, 59 ft. lbs.)
2. Apply thin coat of Molykote AS-880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
3. Apply thin coat of Molykote AS-880N (Part No. K0777YA010) to the frictional portion between pad and inner shim.
4. Install the pads on support.
5. Install the caliper body on support.
Tightening torque: 26.5 Nm (2.7 kgf-m, 19.5 ft. lbs.)
6. Replace the brake hose gaskets with new ones, and then connect the brake hose.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
