subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

All Technical Service Bulletins for Engine Control Module: > < Tail Lamp Relay|Testing and Inspection
Page 1
background image

Engine Control Module: Customer Interest
Engine Controls - DTC P0607 Diagnostic Information

NUMBER: 11-91-08

DATE: 12/05/08

APPLICABILITY: 
2004-2008MY Impreza
2004-2008MY Forester
2005-2008MY Legacy/Outback
2006-2007MY Tribeca

SUBJECT: 
DTC P0607 Control Module Performance

Introduction

The purpose of the bulletin is for information purposes when diagnosing DTC P0607. The following checks and information is in addition to what is
listed in the Subaru Service Manual. This information is to be used in
conjunction with the service manual.

Repair Procedure/Information

Additional items to check:

^

Rapid drop of voltage from a dead battery

^

Loose battery terminals

^

Loose ECM ground terminal

^

A short or open to the power or ground circuit

If the malfunction criteria are met, the CEL will illuminate, the vehicle will go into fail safe and the throttle valve opening will be fixed at 6°. Fail safe
will recover to normal mode if the ECM judges the criteria "OK" at the time of the next engine start. The CEL will not turn off until the "OK" driving
cycle is completed 3 times in a row. The judgment is decided by the ECM to keep the CEL On or Off at the time the ignition switch is turned from ON to
OFF. The ECM keeps DTC P0607 in memory even after the indicator light goes out. Therefore, it is important to erase memory after the repair is
completed.

Detail list of applicable model and engine type.

All Technical Service Bulletins for Engine Control Module: > < Tail Lamp Relay|Testing and Inspection