Impreza WRX STI F4-2.5L DOHC Turbo (2007)
4) Install the universal joint.
5) Connect the tie-rod end and knuckle arm, and tighten with castle nut.
Tightening torque (Castle nut):
27 Nm (2.75 kgf-m, 19.9 ft. lbs.)
CAUTION:
When connecting, do not hit the cap at bottom of tie-rod end with hammer.
6) After tightening the castle nut to specified torque, tighten it further within 60° until cotter pin hole is aligned with the slot in nut, and then bend the
cotter pin to lock.
7) Install the front stabilizer to vehicle.
8) Install the front exhaust pipe assembly. (Non-turbo model)
9) Install the sub frame.
10) Install the under cover.
11) Align the center of roll connector.
12) Install the steering wheel.
13) Install the front wheels.
14) Tighten the wheel nuts to specified torque.
Tightening torque:
90 Nm (9.0 kgf-m, 65.1 ft. lbs.)
15) Connect the battery ground cable to battery.
16) Pour fluid into the oil tank, and bleed air.
17) Check for fluid leaks.
