Impreza WRX STI F4-2.5L DOHC Turbo (2007)
22) Tighten the adjusting screw to specified torque.
Tightening torque:
7.4 Nm (0.75 kgf-m, 5.4 ft. lbs.)
23) After tightening to the specified tightening torque, loosen it by 37°.
24) Remove the tie-rod.
25) Verify that play is within specified value.
26) Loosen the adjusting screw, and then apply liquid gasket to at least 1/3 of the entire perimeter of adjusting screw thread.
Liquid gasket:
THREE BOND 1141 (Part No. 004403006)
27) Tighten the adjusting screw.
Tightening torque:
9.8 Nm (1.0 kgf-m, 7.2 ft. lbs.)
28) After tightening to the specified tightening torque, loosen it.
29) Tighten the adjusting screw.
Tightening torque:
4.8 Nm (0.49 kgf-m, 3.5 ft. lbs.)
30) After tightening to the specified tightening torque, loosen it.
31) Tighten the adjusting screw.
Tightening torque:
4.8 Nm (0.49 kgf-m, 3.5 ft. lbs.)
32) After tightening to the specified tightening torque, loosen it by 37°.
33) Install the lock nut. While holding the adjusting screw with a wrench, tighten lock nut using ST.
ST 926230000 SPANNER
Tightening torque (Lock nut):
40 Nm (4.1 kgf-m, 29.5 ft. lbs.)
NOTE:
Hold the adjusting screw with a wrench to prevent it from turning while tightening lock nut.
34) Install the tie-rod into rack.
Tightening torque:
90 Nm (9.0 kgf-m, 65.1 ft. lbs.)
