subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Tire Monitoring System|General|Page 3568 > < Tire Monitoring System|General|Page 3566
Page 2
background image

CONDITIONS JUDGED AS A FAILURE

The receiver decides that the system has failed when any of the following conditions is met.

-

EEPROM abnormal: The written data does not coincide with the loaded data when the ID is registered.

-

Data reception failure: Transmitter data could not be received for 10 minutes or more while driving at a speed exceeding 40 km/h (24.9 MPH).

-

Function code abnormal: "Re-measure" function code is received for 5 times in series, though the pressure change compared to the last data was
within 7 kPa (0.071 kgf/sq.cm, 1.02 psi) while driving at a speed exceeding 40 km/h (24.9 MPH).

-

Air pressure data abnormal: "FFH"* pressure data has been received for 5 times in series while driving at a speed exceeding 40 km/h (24.9 MPH)
.

-

Low battery: Function code for the "low battery" mode has been received for 20 times or more in series.

-

Vehicle speed sensor abnormal: Function code for the "wake" mode has been received while the vehicle speed signal is 6 km/h (3.7 MPH) or
lower
.

*FFH is transmitted when the pressure data exceeds the upper limit (352kPa, 3.59 kgf/sq.cm, 51.05 psi) of pressure detection.

If the indicator comes ON due to low tire pressure, the indicator will turn OFF when the under-inflated tire is inflated to normal pressure.

Tire Monitoring System|General|Page 3568 > < Tire Monitoring System|General|Page 3566