Impreza WRX STI F4-2.5L DOHC Turbo (2007)
8) Remove the rear ABS wheel speed sensor from back plate.
9) Remove the rear drive shaft from rear axle. If it is hard to remove, remove the brake disk rotor using the ST1 and ST2.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE
CAUTION:
^
Do not hammer the drive shaft when removing.
^
Do not damage the oil seal and tone wheel.
10) Remove the rear drive shaft from rear differential using the ST.
ST 28099PA100 DRIVE SHAFT REMOVER
NOTE:
Fit the ST to the bolt (A) as shown in the figure to avoid damage on the side bearing retainer.
