subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Fluid Pan, M/T > < Transmission Gear Oil Inspection
Page 1
background image

Fluid - M/T: Service and Repair
Transmission Gear Oil Replacement

Transmission Gear Oil

REPLACEMENT 

1) Pull out the oil level gauge.
2) Lift-up the vehicle.
3) Remove the transmission under cover.
4) Drain the transmission gear oil completely.

CAUTION:  
Directly after the vehicle has been running or the engine has been long idle running, the transmission gear oil is hot. Be careful not to burn yourself.

NOTE:  
^

Tighten the transmission gear oil drain plug after draining transmission gear oil.

^

Use anew gasket.

5) Lower the vehicle.
6) Pour gear oil into the gauge hole.
Recommended gear oil: 

Use GL-5 or equivalent.

Gear oil capacity: 

4.1 liters (4.3 US quarts, 3.6 Imp quarts) 

7) Check the level of the transmission gear oil.

NOTE:  
^

When inserting the level gauge into transmission gear, align the protrusion on the side of the top part of the level gauge with the notch in the gauge
hole.

^

The gear oil level should be within the specified range marked on the level gauge.

Fluid Pan, M/T > < Transmission Gear Oil Inspection