Impreza WRX STI F4-2.5L Turbo (2008)
1. Remove the trim claws using the flat tip screwdriver (1).
2. Remove the trim claws using the clip remover (2).
Tools
Flat tip screwdriver: Axle length 100 mm
Clip remover: KTC AP20L-10B
2. Remove the trim claws and then remove the rear gate pillar trim using the flat tip screwdriver.
CAUTION: According the following procedures, removing trim. There is the possibility of the trim being damaged.
1. Insert the flat tip screwdriver (1) as shown in the figure, and then remove the trim claws.