Impreza WRX STI F4-2.5L Turbo (2008)
10) Support the sub frame using a jack.
11) Remove the support plate.
12) Remove the rear sub frame.
INSTALLATION
NOTE:
^
Be sure to use a new self-locking nut.
^
Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
1) Install in the reverse order of removal.
Tightening torque: Refer to "COMPONENT" of "General Description " for the tightening torque.
2) Bleed air from brake system.
3) Inspect the wheel alignment and adjust if necessary.
INSPECTION
Check the removed parts for wear, damage and crack, and repair or replace them if faulty.