Impreza WRX STI F4-2.5L Turbo (2008)
-
When airbag control module, front sub sensor, side airbag sensor, curtain airbag sensor and satellite safing sensor are removed, do not reuse the
bolts and nuts. Always use new bolts and nuts for them.
-
Do not drop each airbag module, airbag control module or sensor, subject them to high temperature of 85 °C (185 °F) or more, or let water, oil or
grease get on them; otherwise, the internal parts may be damaged and reliability greatly lowered.
-
After removing all the parts of airbag system, keep the airbag module with the pad side facing upward on a dry, clean and flat surface away from
heat, light sources, moisture and dust.
-
Do not disassemble driver's airbag module, passenger's airbag module, side or curtain airbag modules or pretensioner.
-
When installing steering wheel and steering roll connector, be sure to adjust the steering roll connector.
-
The removed front seat with airbag module must be kept at least 200 mm (8 in) away from walls and other objects.
-
When storing a removed airbag module, do not place it with the pad side of airbag facing downward. Do not place any objects on the airbag
module. Do not pile up the airbag module. If the airbag inflates for some reason when an airbag module pad is touching other objects, it may cause
serious accident.
