Impreza WRX STI F4-2.5L Turbo (2008)
Remove white backing from protector film and template. Spray the protector film and template (the side which the white backing was removed) with
mild detergent mixed with water.
Align protector film and template. Using a squeegee, working from the center towards the edges, remove the air bubbles. Continue until all air bubbles
are removed.
Remove template.
Use a soft clean towel, wipe off excess water and go over edges to insure that protector film is firmly applied.
Technical Service Bulletin # 13-89-08
Date: 080811
Body - Paint Chipping On Rear Quarter Panel
