Impreza WRX STI F4-2.5L Turbo (2008)
9) Place the rib face of the rear side belt into the grooves of the crank pulley, and sandwich the rear side belt with the belt guide holder.
CAUTION: When it is difficult to place the rear side belt to the crank pulley groove, pull out the belt guide holder half way, then place the
rear side belt into the groove so that it comes in between the belt guide holder.
10) Place the tool through the loop of the rear side belt, and set on the crank pulley bolt.
11) While checking for the following, turn the crank pulley slowly to the right by approximately 90° and set the belt guide to the position shown in the
figure.
CAUTION: When turning the crank pulley, always make sure that the belt guide does not slide off from the crank pulley groove.
