Impreza WRX STI F4-2.5L Turbo (2008)
Impact Sensor: Service and Repair
Side Airbag Sensor
Side Airbag Sensor
REMOVAL
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the front outer seat belt.
4. Remove the nuts to remove the side airbag sensor.
CAUTION:
-
Do not separate the side airbag sensor and bracket. It cause the airbag system malfunction.
-
If the sensor is removed from the bracket, replace them with new parts.
5. Disconnect the airbag connector.
INSTALLATION
CAUTION:
-
Do not reuse the bolt and nut.
-
Always use new bolts and nuts for them.
Install in the reverse order of removal.
Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)
