Impreza WRX STI F4-2.5L Turbo (2008)
6) Fill 80 to 90 g (2.82 to 3.17 oz) of specified grease into the inner side of the EDJ outer race.
7) Apply a thin coat of specified grease to the cage pocket and six ball bearings.
8) Insert the six ball bearings into the cage pocket.
9) Align the outer race track and ball positions, and place the shaft, inner race, cage and ball bearings in the original positions, and then fix outer race
in place.
10) Install the snap ring in the groove on the EDJ outer race.
NOTE:
^
Assure that the balls, cage and inner race are completely fitted in the outer race of EDJ
^
Use care not to place the matched position of snap ring in the ball groove of outer race.
^
Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
11) Apply an even coat of the specified grease [20 to 30 g (0.71 to 1.06 oz)] to the entire inner surface of boot. Also apply grease to the shaft.
12) Install the EDJ boot taking care not to twist it.
NOTE:
^
The inside of the larger end of EDJ boot and the boot groove shall be cleaned so as to be free from grease and other substances.
^
When installing the EDJ boot, position the outer race of EDJ at center of the stroke.
13) Put a new band through the clip and wind twice in the band groove of the boot.
14) Pinch the end of band with pliers. Hold the clip and tighten securely.
NOTE: When tightening boot, use care so that the air within the boot is appropriate.
