Impreza WRX STI F4-2.5L Turbo (2008)
7) Secure the reverse check cable to the stay clip.
NOTE: Install the reverse check cable to the upper side of the stay.
8) Install the heat shield cover.
9) Install the rear exhaust pipe and muffler.
10) Install the boot and insulator assembly.
11) Install the console box.
INSPECTION
1) Check if the slider moves smoothly. If it does not, adjust the reverse check cable or check the slider for damage.
2) Check if the gear shifts into reverse when pulling up the slider. If the gear cannot shift into reverse, adjust the reverse check cable.
3) Check that the gear does not shift into reverse when not pulling up the slider. If the gear shifts into reverse, adjust or replace the reverse check
cable.
ADJUSTMENT
1) Set the vehicle on a lift.
2) Remove the under cover.
3) Remove the rear exhaust pipe and muffler.
4) Remove the heat shield cover.
