Impreza WRX STI F4-2.5L Turbo (2008)
Wiper Motor: Service and Repair
Rear Wiper Motor
Rear Wiper Motor
REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the rear wiper arm.
3. Remove the rear gate lower trim.
4. Disconnect the harness connector of wiper motor assembly.
5. Remove the bolt, and then remove the wiper motor assembly.
INSTALLATION
1. Install in the reverse order of removal.
2. Be sure that the pivot cap with the mark facing up, as shown in the figure.
Tightening torque: N.m (kgf.m, ft.lb)
T1: 6.0 (0.61, 4.4)
T2: 8.0 (0.82, 5.9)