L-Series Sedan (3 Door) 2WD F4-1781cc 1.8L SOHC (SPFI) (1986)
FIGURE 2
Step 3)
Install the new spring by placing the bent ends through the
inner pin holes on the inside of the door handle flap. (See Figure 2).
NOTE:
The banded tab of the spring should be installed away from the key lock cylinder side.
Step 4)
Reinstall the door flap handle by:
*
Placing the banded tab of the spring toward the inside shelf of the door handle.
*
Press the door handle flap into position, * Install the retaining pin opposite the key lock cylinder side first, followed by the key lock
cylinder side.
NOTE:
Use only the new retaining pins provided, dispose of the old pins.
XT Coupe models manufactured on or after July 9, 1986 will have the new spring installed in production starting with these VIN's:
Step 5) Reinstall the door handle in the reverse order of removal.
This procedure can be claimed for vehicles within the terms of the Subaru Warranty using:
Operation #
Time
One Outer Door Handle
- R&R
#B915-261
0.6 Hrs.
Each Additional Outer Door Handle -
R&R
#C915-265
ADD
0.5 Hrs.
One Door Handle Flap Spring and 2 new Pins
in each Handle
#C915-271
ADD
0.2 Hrs.
Use Failure Code XDX-48