L-Series Sedan (4 Door) 2WD F4-1781cc 1.8L SOHC (MPFI) (1985)
Thrust Washer/Bearing: Technical Service Bulletins
A/T - Thrust Bearing Assembly Installation
NUMBER 16-25-85
APPLICABILTY
ALL 1985 FWD AND 4WD 4-DOOR SEDAN, STATION WAGON, AND
DATE 11-4-85
XT COUPE VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS
SUBJECT:
SELF CONTAINED THRUST BEARING TOTAL END-PIAY MEASURING PROCEDURE
THIS SERVICE BULLETIN IS SUPPLIED FOR INFORMATION ONLY
FIGURE 1 - THRUST BEARING
All 1985 FWD and 4WD 4-Door Sedan, Station Wagon, and XT Coupe vehicles equipped with automatic transmissions will have the previous style
thrust bearing and selective washer set replaced in production with a new style self contained thrust bearing assembly. (See Figure 1).
Bearing - P/N 806 520 000
Bearing Assy. - P/N 806 520 040
Washer - P/N 803 021 049
This production change starts with transmission number 365875 and the following VIN'S:
4-Door Sedan
233 496
Station Wagon
446 574
XT Coupe
303 494
To install a new self contained thrust bearing assembly into an automatic transmission, follow the procedure below:
PROCEDURE
1)
Remove the pump and thrust bearing from the transmission.
FIGURE 2 LOW AND REVERSE BRAKE GAUGE
2)
Using a depth gauge and the low and reverse brake gauge- (P/N 398 643 600), measure dimension "L". (See Figure 2).