Legacy F4-2.5L DOHC Turbo (2005)
Alarm Module: Service and Repair
Security Control Unit
Security Control Unit
NOTE: The control of security system is carried out in body integrated unit.
REMOVAL
NOTE:
-
If replacing the body integrated unit, check the current setting and note it.
-
When replacing the body integrated unit, all immobilizer keys also must be replaced and registered again.
1. Disconnect the ground cable from battery.
2. Remove the instrument panel lower cover.
3. Disconnect the connector of body integrated unit.
CAUTION: Be careful to keep water and other foreign materials away from body integrated unit.
4. Remove the body integrated unit from the body integrated unit mounting bracket using flat tip screwdriver.
CAUTION: Be careful not to damage the unit when removing it forcibly from the bracket.
5. Remove the clutch pedal stopper arm. (MT model).
6. Remove two body integrated unit bracket mounting bolts, and remove the bracket.
INSTALLATION
Install in the reverse order of removal.
NOTE:
-
When the same body integrated unit is reinstalled in the same vehicle, it is not necessary to register the immobilizer again.
-
Make sure it conforms to the current setting condition after installation.
