Legacy F4-2.5L SOHC (2003)
Trunk / Liftgate Shock / Support: Service and Repair
DISPOSAL
1. GAS STAY
1. Place the gas stay (B) in a vinyl sack (C) before drilling hole with a drill (A).
CAUTION: Prevent the vinyl case from being caught by drill cutting edge
2. Lift body side slightly with piston rods fully extended, and secure body side on vise stand. Drill a hole in 2 to 3 mm (0.08 to 0.12 in) diameter
at a point 10 to 200 mm (0.39 to 7.87 in) from door side, and bleed gas stay completely.
CAUTION: Gas is colorless, odorless, and harmless. However, gas pressure may spray cutting powder or oil. Be sure to wear
dust-resistant goggles.
