Legacy F6-3.0L (2005)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
With VDC
REMOVAL
1. Disconnect the ground cable from battery.
2. Use compressed air to get rid of water and dust around the VDCCM&H/U.
NOTE: When dust and dirt are attached to the terminal, they may cause poor contact.
3. Disconnect the pressure sensor connector.
4. Disconnect the VDCCM&H/U connector with pulling up the lock lever.
CAUTION: Do not pull the harness when disconnecting connector.
5. Disconnect the brake pipes from VDCCM&H/U.
6. Wrap the brake pipe using a vinyl bag not to spill the brake fluid on the vehicle body.
CAUTION: When the brake fluid is attached to vehicle body, wash it off with water and wipe the water.
7. Remove the clips, and then remove the VDCCM&H/U.
CAUTION:
^
VDCCM&H/U cannot be disassembled. Do not attempt to loosen the bolts and nuts.