Legacy F6-3.0L (2005)
Vacuum Brake Booster: Service and Repair
REMOVAL
1. Remove or disconnect the following parts at engine compartment.
1
Disconnect the connector for brake fluid level gauge.
2
Remove the brake pipes from master cylinder.
3
Remove the master cylinder installing nuts.
4
Disconnect the vacuum hose from brake booster.
2. Remove the following parts from pedal bracket.
1
Snap pin and clevis pin
2
Four brake booster installing nuts
3. Remove the brake booster while shunning brake pipes.
NOTE:
^
Do not apply strong impact to booster shell and vacuum pipe.
^
Be careful not to drop the brake booster. The brake booster should be replaced if it has been dropped.
^
Use special care when handling the operating rod. If excessive force is applied to operating rod sufficient to cause a change in the angle in
excess of ±3°, it may result in damage to the power piston cylinder.
^
Use care when placing the brake booster on the floor.
^
Do not change the push rod length.
CAUTION:
^
Do not disassemble the brake booster.
^
If external force is applied from above when brake booster is placed in this position, the resin portion as indicated by "P", may be damaged.
