Legacy F6-3.0L (2005)
3
Remove the fuel pipe protector (LH).
4
Remove the ignition coil.
5
Remove the rocker cover (LH).
9. Turn the crankshaft clockwise until the cam is set to position shown in the figure.
10. Measure the clearance of intake valve and exhaust valve using thickness gauge (A).
NOTE:
^
Measure it within the range of ±30° that shown in the figure.
^
Measure it in low lift cam for intake side.
^
Insert the thickness gauge in as horizontal a direction as possible with respect to the valve lifter.
Valve clearance
Intake: 0.20[+0.04/-0.06] mm (0.0079[+0.0016/-0.0024 inch)
Exhaust: 0.35 ± 0.05 mm (0.0138 ± 0.0020 inch)
^
If the measured value is not within specification, take notes of the value in order to adjust the valve clearance later on.
11. If necessary, adjust the valve clearance.
12. Further turn the crank pulley clockwise and then measure the valve clearances again.
13. After inspection, install the related parts in the reverse order of removal.
