Legacy F6-3.0L (2005)
Engine Control Module: Service and Repair
Engine Control Module (ECM)
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the lower inner trim of passenger's side.
3. Detach the floor mat of front passenger seat.
4. Remove the protect cover.
5. Remove the nuts and bolts which hold ECM to bracket.
6. Remove the clip (A) from bracket.
7. Disconnect the ECM connectors, and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage to fuel injection system.
-
When replacing the ECM, be careful not to damage the harnesses and connectors.
-
When replacing the ECM, immobilizer system must be registered. For doing so, all ignition keys and ID cards should be prepared. Refer to
"REGISTRATION MANUAL FOR IMMOBILIZER".
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)
