Legacy F6-3.0L (2005)
NOTE: When an incorrect weight amount is entered, error will be generated and the DTC will be input.
17. {Put threshold weight with the position on the passenger seat shown with service manual Continue: "YES", Quit: "NO"} is displayed. Check
the seat position, assemble the weight A and weight B, and then press the [YES] key.
NOTE:
-
DTC is detected when selecting the "NO" in this step.
-
Place the weight in the seat center, making sure the firm contact with the backrest.
-
Do not touch or give any impact to the vehicle within 20 seconds after pressing the [YES] key.
-
When the {System calibration is unsuccessful See service manual Press "YES" to END} is displayed, go to step 19.
18. When the {System calibration Is successfully completed Press "YES" to END} is displayed, press the [YES] key to finish the diagnosis.
19. When the {System calibration is unsuccessful See service manual Press "YES" to END} is displayed, the system is malfunctioning. Turn the
ignition switch to OFF once. Read the DTC, repair the trouble cause, and then perform the system calibration again.
See: Reading and Clearing Diagnostic Trouble Codes/Displaying & Reading Trouble Codes
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions/Manufacturer
Code Descriptions/Occupant Detection System - Diagnostics
CAUTION: If the system adjustment fails and stop the operation, DTC {Adjustment/Inspection halt} will be recorded and airbag warning
light will illuminate. If the DTC except {Adjustment/Inspection halt} is displayed, calibrate the system after the malfunction is repaired.
INSPECTION
COMMUNICATION FOR INITIALIZING IMPOSSIBLE
DETECTING CONDITION:
Defective harness connector
TROUBLE SYMPTOM:
Communication is impossible between occupant detection control module and Subaru Select Monitor.