Legacy F6-3.0L (2005)
forty times with the engine running, and make comparison of the leaked portion immediately after and several hours after this operation.
1. Leakage from e
The cylinder seal is damaged. Replace the rack bush with a new one.
2. Leakage from f
There are two possible causes. Take the following step first. Remove the pipe assembly B from the valve housing, and close the circuit with
ST.
ST 926420000 PLUG
Turn the steering wheel from lock to lock about thirty to forty times with the engine running, then make comparison of the leaked portion
between immediately after and several hours after this operation.
^
If leakage from f is noted again:
The oil seal of pinion & valve assembly is damaged. Replace the pinion & valve assembly with a new one. Or replace the oil seal and parts that
are damaged during disassembly with new ones.
^
If oil stops leaking from f:
The oil seal of rack housing is damaged. Replace the oil seal and the parts that are damaged during disassembly with new ones.
Assembly
The content of this article/image reflects the changes Identified in
TSB # 18-97-06
as of 01/04/06
and applies to 2005 Legacy and Baja models
Steering Gearbox
ASSEMBLY
RACK HOUSING ASSEMBLY
1. Using a press, install the bushing to the gearbox installation portion.
2. Insert the ST into rack.
ST 34199AG030 GUIDE
3. Install the seal ring to piston portion of rack.
