Legacy F6-3.0L (2005)
31. Install a new boot band. Using band clamp pliers, caulk the boot band until caulking part clearance is 2 mm (0.079 inch) or less.
32. Fix the boot end with clip (small).
33. After installing, check the boot end is positioned into groove on tie-rod.
34. If the tie-rod end has been removed, screw in the lock nut and tie-rod end to screwed portion of tie-rod, and then tighten the lock nut temporarily in
a position as shown in the figure.
Installed tie-rod length L: 31 mm (1.22 inch)
