Legacy F6-3.0L (2005)
35. Inspect the gearbox as follows:
"A" Holding the tie-rod end, repeat lock to lock two or three times as quickly as possible.
"B" Holding the tie-rod end, turn it slowly at a radius one or two times as large as possible.
After all, make sure that the boot is installed in specified position without deflation.
36. Remove the gearbox from ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
37. Install the four pipes on gearbox.
1. Connect the pipe A and B to four pipe joints of gearbox.
Tightening torque: Refer to COMPONENT.
2. Connect the pipe C and D to gearbox.
Tightening torque:
Pipe C: 37 Nm (3.8 kgf-cm, 27.3 ft. lbs.)
Pipe D: 29 Nm (3.0 kgf-cm, 21.4 ft. lbs.)
2.CONTROL VALVE ASSEMBLY
Specified steering grease: VALIANT GREASE M2 (Part No. 003608001)
1. Clean all parts and tools before reassembling.
2. Apply a coat of specified power steering fluid to the inner wall of valve housing.
3. To avoid scratching the oil seal, apply a coat of grease to the contact surface of installer and oil seal.
4. Verify the oil seal direction.
Attach the oil seal to installer and position in valve housing before pressing into place.
