Legacy F6-3.0L (2005)
8. Install the rear ABS wheel speed sensor and brake cable bracket.
9. Adjust the parking brake lever stroke by turning adjuster.
10. While applying the parking brake and depressing the brake pedal, tighten a new axle nut (olive color) to the specified torque and lock it securely.
Tightening torque: 240 Nm (24.5 kgf-cm, 177 ft. lbs.)
CAUTION:
^
Install the wheel after installation of the axle nut. Failure to follow this rule may damage the wheel bearing.
^
Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage wheel bearing.
11. After tightening the axle nut, lock it securely.
12. Install the wheel and tighten the wheel nuts to specified torque.
Tightening torque: 110 Nm (11.2 kgf-cm, 81.1 ft. lbs.)
DISASSEMBLY
Using the ST and a hydraulic press, drive hub bolts out.
ST 28399AG000 HUB STAND
CAUTION:
^
Be careful not to hammer the hub bolts. This may deform the hub.
^
Do not reuse the hub bolt.
NOTE: Since the hub unit bearing can not be disassembled, only hub bolts can be removed.
ASSEMBLY
1. Attach the hub to ST securely.
ST 927080000 HUB STAND
2. Using a press, press the new hub bolts until their seating surfaces contact the hub.
