Legacy F6-3.0L (2005)
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
12. Remove the BJ boot or EBJ boot in the same procedure as DOJ boot.
NOTE: Further disassembly of axle is impossible because the BJ and EBJ cannot be disassembled.
Front Drive Shaft Assembly
The content of this article/image reflects the changes Identified in
TSB # 18-97-06
as of 01/04/06
and applies to 2005 Legacy and Baja models
Front Drive Shaft
ASSEMBLY
NOTE: Use specified grease. PTJ side: NSG301 (Part No. 28395AG020)
1. Place the PTJ boot at the center of shaft.
2. Align alignment marks and install the trunnion on the shaft.
3. Install the snap ring to shaft.
CAUTION: Confirm that the snap ring is completely fitted in shaft groove.
4. Fill 100 to 110 g (3.53 to 3.88 oz.) of specified grease into the interior of PTJ outer race.
5. Apply a thin coat of specified grease to the roller kit and trunnion.
6. Align alignment marks on roller kit and trunnion and install the roller kit.
CAUTION: Be careful with the roller kit position.
