Legacy F6-3.0L (2005)
D: ASSEMBLY
NOTE: Use specified grease.
BJ side: NTG2218-M (Part No. 28395AG010)
EBJ side: NTG2218-M (Part No. 28395AG010)
DOJ side: NKG205 (Part No. 28495AG000)
1. Install the BJ or EBJ boot in specified position, and fill it with 60 to 70 g (2.12 to 2.47 oz.) of specified grease.
2. Place the DOJ boot at the center of shaft.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
3. Insert the DOJ cage onto shaft.
NOTE: Insert the cage with the cut-out portion facing the shaft end, since the cage has an orientation.
4. Install the DOJ inner race on shaft and fit the snap ring with pliers.
NOTE: Confirm that the snap ring is completely fitted in the shaft groove.
5. Install the cage to inner race fixed upon shaft.
NOTE: Fit the cage with the protruded part aligned with the track on the inner race and then turn by a half pitch.
6. Fill 80 to 90 g (2.82 to 3.17 oz.) of specified grease into the interior of DOJ outer race.
7. Apply a coat of specified grease to the cage pocket and six balls.
8. Insert six balls into the cage pocket.
