Legacy F6-3.0L (2005)
1. Remove the cowl panel.
2. Remove the molding.
3. Tape the body side of the circumference of windshield glass for protection.
4. Make a hole in the adhesive part using drill or knife.
5. Pass the piano wire through the hole, and attach securely both the wire ends to pieces of wood.
6. Pull the wire ends alternately to cut off the adhesive part.
CAUTION:
-
Do not tightly pull the piano wire against the windshield glass edge.
-
Be careful not to damage interior and exterior parts.
-
When removal is made with area close to instrument panel, place a protection plate over it. Pay particular attention to the removal.
-
Do not cross piano wires. Otherwise they may be cut.
INSTALLATION
1. Clean the external circumference of windshield glass with alcohol or white gasoline.
2. Remove the adhesive layer on the body using cutter knife to obtain smooth face of 2 mm (0.08 in) thick.
CAUTION: Be careful not to damage the body and paint surface.
3. Clean the body with alcohol or white gasoline to eliminate cutting power, dust and dirt completely from body.
4. Install the dam rubber.
