Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
-
Limit: 0.05 mm (0.0020 inch)
6. Inspect bushing at connecting rod small end, and replace if worn or damaged. Also measure the piston pin clearance at the connecting rod small end.
Clearance between piston pin and bushing:
-
Standard: 0 - 0.022 mm (0 - 0.0009 inch)
-
Limit: 0.030 mm (0.0012 inch)
7. Replacement procedure is as follows.
a. Remove bushing from connecting rod with ST 499037100 connecting rod bushing remover and installer, or equivalent and press.
b. Press bushing with ST 499037100 connecting rod bushing remover and installer, or equivalent after applying oil on the periphery of bushing.
c. Make two 3 mm (0.12 inch) holes in bushing. Ream the inside of bushing.
d. After completion of reaming, clean bushing to remove chips.
