Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
b. Press out bearing together with backing washer using pipe of I.D. 38.5 to 39.5 mm (1.516 to 1.555 inch) and press.
CAUTION: Do not reuse removed bearing.
c. Remove oil seal.
CAUTION: Do not reuse removed oil seal.
d. Fit pinion and valve assembly into valve housing.
NOTE: Apply ATF DEXRON II to outer diameter surface of input shaft and outer surface of valve body seal ring, and pay special attention not
to damage seal when inserting pinion and valve assembly.
e. Secure valve assembly to ST1 and ST2.
f.
Put ST3 over pinion, and insert oil seal, then force-fit oil seal into housing using ST4.
NOTE:
^
Apply ATE DEXRON II to oil seal and ST3, being careful not to damage oil seal lip.
^
Push oil seal until ST3 contacts housing end face.
g. Remove ST3, and fit backing washer.
