Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
3. Drive out spring pin (6), and pull out 3-4 fork rod (7) and shifter fork (8).
NOTE: When removing rod, keep other rods in neutral. Also, when pulling out straight pin, remove it toward inside of case so that it may not hit
against case.
4. Drive out straight pin (12), and pull out 1-2 fork rod (10) and shifter fork (11).
5. Pull out straight pin (12), and remove idler gear shaft (13), reverse idler gear (14) and washer (15).
6. Remove outer snap ring (16), and pull out reverse shifter rod arm (17) from reverse fork rod (18). Then take out ball, spring and interlock plunger
from rod. And then remove rod.
NOTE: When pulling out reverse shifter rod arm, be careful not to let ball pop out of arm.
7. Remove reverse shifter lever (19).
8. Remove differential side retainers using Special Tool (ST). ST 499787000 Wrench Assembly, or equivalent.
9. Remove outer snap ring (20) and pull out speedometer driven gear (21). Next, remove vehicle speed sensor 2, oil seal, speedometer shaft (22) and
washer.
