Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Keyless Entry Transmitter: Testing and Inspection
2B1: CHECK TRANSMITTER BATTERY.
1. Remove battery from transmitter.
NOTE: To prevent static electricity damage to transmitter printed circuit board, touch steel area of building with hand to discharge static
electricity carried on body or clothes before disassembling transmitter.
2. Measure voltage battery.
NOTE:
-
Battery discharge occurs during measurement. Complete measurement within 5 seconds.
-
During battery voltage measurement, voltage falls more than 1.8 volts during 3 seconds period. Weak battery is indicated. Replace battery.
CHECK:Is the voltage more than 2 V?
YES:
Go to step 2B2.
NO:
Replace transmitter battery. (Use CR2032 or equivalent.)
2B2: CHECK LED OF TRANSMITTER.
1. Press either the LOCK/ARM or UNLOCK/DISARM button six times to synchronize with the keyless entry control module.
2. Press the LOCK/ARM button.
CHECK:Does the LED blink one time?
YES:
Go to step 2B3.
NO:
Replace transmitter.
2B3: CHECK LED OF TRANSMITTER.
Keep the LOCK/ARM button pressed.
CHECK:Does the LED blink one time and then turn on?
YES:
Go to step 2B4.
NO:
Replace transmitter.
2B4: CHECK LED OF TRANSMITTER.
Press the UNLOCK/DISARM button.
