Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Mirrors: All Technical Service Bulletins
Instruments - Door Mirror is Loose
NUMBER: 12-94-06
DATE: 10/03/06
APPLICABILITY: 2000~04MY Legacy & Outback;
2003MY and After Baja
SUBJECT:
Loose Door Mirror Screws
INTRODUCTION
If you encounter a customer complaint that the door mirror is loose follow the repair procedure listed.
PARTS INFORMATION
REPAIR PROCEDURE/INFORMATION
1)
Confirm that the door mirror is loose.
2)
Remove the interior mirror gusset cover (refer to the applicable Subaru Service manual found on the STIS web-site) and check the mirror screws
for proper torque specification, 4.5 + 1.5 Nm (0.46 + 0.15 kgf-m, 3.3 + 1.1 ft-lb). Tighten as necessary. If the screws are at the proper torque
specification and the mirror is still loose, go to step 3.
3)
There are 3 mirror stay screws located on the bottom of the mirror assembly, two of which are accessible without removing the mirror. Check
those two for proper torque specification, 2.5 + 0.1 Nm (0.25 kgf-m, 1.8 ft-lb). If they are loose, most likely the third will be also. Remove the
door mirror (refer to the applicable Subaru Service manual found on the STIS web-site). Remove the 3 stay screws and use a wire brush to clean
any adhesive material that may be present on the screw threads. Apply Loctite(R) 271 to the screw threads, install screws and torque to proper
specification. Reinstall mirror.
Note:
If new screws are required, use part number 904310072, and apply Loctite(R) 271.